9/3/2023 0 Comments Mandolin tuner spacing![]() ![]() This enables the tuners to fit properly (the sketches illustrate what happens when the holes are not square to the back of the peghead). Since the F-style peghead commonly has a tapered thickness, this method keeps the holes square to the back of the peghead where the plate will sit flat. We recommend clamping the jig to the back of the peghead, and drilling the holes from the back. The pins should hold the jig positioned while you clamp it to the back of the peghead.ĥ. With the tip of the pins pressed into the wood, slide the jig down the pins to contact the peghead. Place the sharp pointed transfer pins through the outer holes of the jig, and position the points on the peghead where the corresponding peg hole centers are marked. ![]() Draw a pair of straight lines, tangent to the arcs, that taper slightly toward the tip of the peghead and give the tuners a pleasing "look" and functional location.Ĥ. This will keep the baseplates from hanging over the edge of the peghead. Draw an arc, parallel to the edge of the peghead, which is one-half the width of the baseplate, plus. Square up from the back to meet the four cross lines on each side, and connect those lines to make four lines across the back of the peghead.ģ. To transfer the hole locations to the back of the peghead, draw four lines, each connecting the centers of the holes directly across the peghead from each other. You should double-check these, since several sizes and variations of this peghead exist.Ģ. The illustrations are suggested peghole locations. The tuner baseplates are usually not located parallel to each other, but are slightly closer together toward the peghead tip. Lay out the location of the string posts on the front face of the peghead. This drill jig can also be used to retrofit modern tuners onto older mandolins.ġ. The Mandolin Tuner Drill Jig is designed for drilling accurately spaced 1/4"-diameter pegholes for installing modern mandolin tuning machines. View All WOODSTAX - Shop Tonewood by the Piece.View All All Hardware + Parts by Instrument. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |